Amplifier Wiring guide

1. Install Power Cable

Connect the power cable onto the positive terminal of the battery making sure the fuse holder is withing 6 inches of the battery.
DO NOT FIT FUSE IN ITS HOLDER UNTIL INSTALLATION IS COMPLETE.
2. Power Cable to boot

The power cable needs to be run down one side of the car, out of the way of other wires if possible.
A suitable place to run the cable is usually beneath the door sill panels.
3. Remote & RCA Cable

Run the remote and RCA cables down the opposite side of the car from music source to boot. Again ensure these cables are securely properly in place away from anything that may cause interference.
4. Install Earth Cable

In the boot bolt your earth cable directly to a bare metal part of your car, avoid using any seatbelt fixings.
5 : Wire your amplifier

Connect the power cable from battery to ‘+12V’ terminal.
Connect earth cable to the ‘GND’ terminal.
Connect the remote cable to ‘REM’ terminal.
Connect RCA leads to the ‘Line in’ terminals.
6. The last step

Insert Fuse into Fuse Holder

For subwoofer wiring go here. For speaker wiring check the manual.